Changes between Version 22 and Version 23 of Tutorials/Wireless/mmwave Paam Link Rate

Timestamp:

Mar 26, 2024, 1:24:49 AM (20 months ago)

Author:

zhenzhou77

Comment:

—

Tutorials/Wireless/mmwave Paam Link Rate

@@ -135 +135 @@
 ==== Configure IBM 28GHz PAAM ====
 COSMOS uses the IBM 28GHz PAAM API to configure and initialize the PAAM boards. 
-Under {{{PAAM_Control}}}, use the following command to configure the PAAM boards in **terminal 1**: 
-    {{{#!shell
-    root@srv1-lg1:~/PAAM_Control# python3 main.py
+Under the console in **terminal 2**, please run the following 4 commands:
+    {{{#!shell
+    <user_name>@console:~$ curl "http://am1.orbit-lab.org:5054/array_mgmt/configure?dev_name=rfdev2-1.sb2.cosmos-lab.org&ics=0&num_elements=16&txrx=tx&pol=h&theta=0&phi=0"
     }}}
 The following message will print out to indicate that the PAAM board is being successfully configured:
-    {{{#!shell
-Opened port to FPGA
-Logged in to Petalinux
-Started command parser on Zynq
-sdpar_prog.py /version: Version is PAWR_v1.2.0
-Using baseline FPGA control IP
-Reset the Phased Array
-Initialization of IC 0 was successful
-Initialization of IC 1 was successful
-Initialization of IC 2 was successful
-Initialization of IC 3 was successful
-IC0 current: 2.2629521016617793 status: On
-IC1 current: 1.3685239491691104 status: On
-IC2 current: 0.19550342130987292 status: Off
-IC3 current: 0.07820136852394917 status: Off
-Closed port to Zynq
-Opened port to FPGA
-Logged in to Petalinux
-Started command parser on Zynq
-sdpar_prog.py /version: Version is PAWR_v1.2.0
-Using baseline FPGA control IP
-Reset the Phased Array
-Initialization of IC 0 was successful
-Initialization of IC 1 was successful
-Initialization of IC 2 was successful
-Initialization of IC 3 was successful
-IC0 current: 2.29227761485826 status: On
-IC1 current: 1.3587487781036167 status: On
-IC2 current: 0.15640273704789834 status: Off
-IC3 current: 0.16617790811339198 status: Off
-Closed port to Zynq
-Experiment Started!
-    }}}
-Notice this program will **hang** there to indicate that the PAAM board is on, if you wish to turn off the ICs on the PAAM boards, please **press {{{CTRL+C}}} once**. 
-
-
 
 === Experiment Execution ===